HOLLEY SYSTEMAX UPPER/LOWER INTAKE WITH 1" SPACER
VERY GOOD COND THIS IS FOR A 302/FOX OFCOURSE I
WANT $425 bo-
PRO M 77 MM MASS AIR FOR 30LB INJECTORS $125- FOR
ANOTHER $5 ...
Set of 4 chrome bullet wheels. Rear are deep lip
17x10.5 with 315's and fronts are 17x9 with 245's
seen on my car in the picture. I was trying to
sell the whole car and get a ...
Engine and tranny out of 90 GT, ran great when
pulled. car was hit in rear. T-5 tranny with B&M
shiter. Motor has only 65K orig. miles.
Located in ohio, willing to deliver ...
Just added all these parts to EBay. Search under
my EBay username of Bigbadwolf1
OR click the link below........
http://motors.search.ebay.com ...
This is a 1988 Mustang 5.0 LX. Car has a vaccum
leak which costs only $5.00 to fix. We bought this
car in 2002 at the time the mileage showed 074948.
We took out the 85mph and ...
This is a professionaly built Ford 351W Engine. It
consists of a 1979 block which is one of the
thickest 351W blocks ever made. This brand new
engine has been Pressure Tested ...
Super clean, senior adult-owned, Y2000GT, less
than 37,000 miles, with Paxton intercooled, Paxton
Novi 2000 supercharger, race housing and impeller;
rebuilt and upgraded under ...
Unfinished 1985 Mustang GT project. This car is a
ground-up build that I started in 1998. I started
with a 65,00 mile bare shell from Florida and have
been building ever sin ...
I need a 351w roller cam block. They were found in
trucks 1995 and up. I will be boring it out to
.040" so a small ridge should be no problem.
Perfer local I'm in Rhode Island
I am parting a 66 mustang coupe wuth good fenders
and doors plus many other parts
I have other years parts as well and all must go
as I will be moving soon
rsanter@aol.com