I'm looking for a 6.5 inch or 6.87 inch 6 rib
crank pulley for a vortech supercharger. It would
have come with the original A-trim high output
kit.
There have got to lots o ...
This is a reproduction Saleen T1 race wing for
SN95s. These are HARD to come buy and even HARDER
to find authentic - $375 best offer or trades?
buyer assumes responsibility fo ...
1979 351W shortblock with standard bore and
standard crank journals. This has the football
style rods. I hade checked over the block the
best I could and found no defects ot ...
This is a clean, well kept and maintained, Florida
driven 2004 Ford F150 FX4. This 2004 Ford F150 FX4
is in very good condition for the year and the
miles. I personally drive ...
Ford part #M3.63X1.34X13.5, mounting screws (2)
for the driver's power seat control panel. Can't
find a reference to this part number. Can anyone
offer some info?
RAM Aluminum Flywheel #RAM2529 (419.95)
Centerforce DF CLutch #CTFDF021048 (309.95)
Used for only 4k miles. Going Auto. Will seperate,
$275 for flywheel and $150 fo clutch
Custom built 4 point roll bar for 94-04 mustang
hardtops. Made of 1 3/4 inch DOM seamless tube,
.120 SCCA leagl. Bolt in or weld-in. Never been
used. Located in northern Ca ...
1994 Mustang GT convertible with an almost new CHP
347 with Kenne Bell supercharger. Anderson PMS
tuner. Tremec 3550 5 spd, Simmons 17in rims with
315 radial slicks on rear. O ...
1974 351 windsor block that has been hot tanked,
inspected and bored to .025 over. The reason for
the .025 is this is a project a friend started and
stopped due to getting a d ...