I am parting with my 86 GT in order to pay for
another one. I love this car, but I am just
looking to move on. The car has:
64k mile long block
Cobra INtake with 70mm TB
F ...
Will sell any parts off it expect body parts.
Going to turn it into a full out race car. There
is a trick flow street heat intake, brand new AOD
have receit for recent rebu ...
Lunati hydraulic roller custom ground for 1.7's
this cam works great w/power adders or N/A cam
card included 230/230 dur @ .050" will clear stock
pistons low miles
Free shipp ...
Me and the Mrs are gauging interest on this. She
is not sure if she likes the "06's enough to get
rid of her car and we would take a bath on a trade
in, so we are seeing what ...
I got a black 1995 gt 5.0 8 cyl auto tranny
interior is black and tan leather i just got it a
1 months ago from a chick with like 77,xxx miles
got it did a full tune up, new b ...
Anderson Ford Motorsports custom hydraulic roller
for 1.7's, ground for best possible naturally
aspirated performance, used but perfect shape
email me for specs
The car is completely redone and just needs a
roll cage. Here is a small list of some of the
things done there are so much i can keep going
on.
This car has been completely ...
'88 Mustang GT prepared for road-racing (not
street-legal), in NJ. Raced with EMRA, would also
be legal for NASA. The car had a lot of things
done and a lot of money spent (h ...
Engine and tranny out of 90 GT, ran great when
pulled. car was hit in rear. T-5 tranny with B&M
shiter. Motor has only 65K orig. miles.
Located in ohio, willing to deliver ...
this car is the ultimate s/c or nitrous set-up,
car has everything ,with S-trim has gone numerous
10:00's in 1/4 and 6:30's at over 108mph in the
1/8 with only a 1.64 60 ft. t ...
74 351W block with standard bore (4.00) in good
condition but needs to have the cylinders
"cleaned" to remove any rust from years of sitting
in my basement. Also, a Comp Cams ...