Cranks and runs. Needs work. Minor dents. Needs
Rear plexiglass/ glass / plastic window. Top motor
works. Dash is cracked. Driver seat has tear.
Heater and air conditioner wor ...
this car is in great condition for its age. lets
start with the mods. mac equal length headers, o/r
x pipe, flowmaster mufflers with turndowns,
centerforce clutch replaced wit ...
If you have or know anyone who has a T5
bellhousing fork cover I need it.
Can't let the dirt into my new clutch you know.
If you have one and not planing to get rich off o ...
these rims came off a 1995 mustang cobra that was
involved in a wreck 2 rims are bent the others
seem to be fine the 2 front rims that are bent
were still able to be driven on ...
I don't know if anyone would be interested or not,
but I'm wanting to trade my Turbo Coupe for a fuel
injected 5.0 HO with an AOD tranny (in a car or
not). This setup will be ...
NEW ONLY FEW PASSES R302 block .030 over with
eagle rotaing assembly 347..4340 forged crank
h-beam rods with JE domed pistons...13.3-1
compression with 58cc "INLINE" STYLE hea ...
Roush Stage 3 Ft bumper cover, still in original
box-never installed, UA black paint code, minor
scuffs from cardboard box that will more than
likely polish. A neat way to ach ...
FOR PARTS ONLY!!! This car is a '98 & has 83000
miles...Factory c/d ,cassete...Black ext, black
interior..interior is excellent...front cap
damage..(HOOD AND BUMPER COVER ONLY ...
the engine is from a 90' fox mustang driven
by
a woman its life, never run hard. it had 125,000
when it was taken out.$600
the trans came out of the same car at ...