I have a set of brand new K-Motion valve springs
for sale. Part #K-800.
Number of Springs Per Valve: Dual
Outside Diameter of Outer Spring (in): 1.460
in.
Coil ...
I have up for sale a liberty pro shifted Tremec
TKO transmission 26 spline input shaft/ 31 spline
output shaft. It has a mcleod scattershield to
link it to a small block ford, ...
I'm looking for a 6.5 inch or 6.87 inch 6 rib
crank pulley for a vortech supercharger. It would
have come with the original A-trim high output
kit.
There have got to lots o ...
This is a reproduction Saleen T1 race wing for
SN95s. These are HARD to come buy and even HARDER
to find authentic - $375 best offer or trades?
buyer assumes responsibility fo ...
http://www.fototime.com/7D1A8E81F8976AD/stand
ard.jpg
The car has had $3100 worth of service and is in
excellent condition. I have a full desc ...
This is a clean, well kept and maintained, Florida
driven 2004 Ford F150 FX4. This 2004 Ford F150 FX4
is in very good condition for the year and the
miles. I personally drive ...
1979 351W shortblock with standard bore and
standard crank journals. This has the football
style rods. I hade checked over the block the
best I could and found no defects ot ...
1974 351 windsor block that has been hot tanked,
inspected and bored to .025 over. The reason for
the .025 is this is a project a friend started and
stopped due to getting a d ...
Built ‘93 black LX. Has fresh 347 pro built by
Pauls Automotive Engineering in Cincinnati, OH
that specializes in Shelby restos and American
Iron engines. Dynoed at 400 rwhp ...