Due to a military PCS to alaska I am forced to
sell both of my cars and get a daily driver for
the alaskan winters.
Will sell as a complete race setup or rolling
chasis or ...
2.3 turbo intercooled engine complete exhaust air
intake parts radiator most wiring of car engine
processor throttle cable starter coil overflow
bottle and other items-$1200/5 ...
I am looking for some Dagenham parts. I need a
Bell Housing for a 200 cid 6cyl., Ft. Brg
Retainer, Clutch Release Fork, and Rev. Idler &
Shaft.
Thanks
dysart22
i need an extension housing for a tr-3650-4 tremec
5-speed transmission its out of a 2003 mustang gt
the extension housing has cracks in it and i just
need the housing
For sale is an 1989 mustang LX with GT ground
effects and cobra wing. Body is rust free. Motor
is a 1972 351 windsor, world products windsor jr
heads, K.B. pistons, polished ...
Tremec 3550
has around 5000 miles on it
comes with.....
Hurst short throw shifter
hays aluminum flywheel
Centerforce dual-friction clutch
Lakewood Blow Proof Bell hous ...
In storage 302/289 engine from 1968 mustang,
totally diss-assembled and greased in 1976. Engine
bored .040, crane cam, torker aluminum intake,
blowproof and aluminum bell hous ...
I have a 8.8 rear end housing with welded tubes
out of a '91 GT. It also has the tabs welded on it
for a Wolfe single sway bar. Local pickup in
Michigan. Make me an offer. Pic ...
Listing for a friend....
For sale is a 95% Turbo set-up. The turbo and
headers are new never used. The intercooler and
cold piping are from a twin kit he had on his car.
To ...
THESE ARE PARTS THAT MY FRIEND IS TRYING TTO
CLEAR-OUT OF HIS STORAGE!
• Flowtech headers 86-93 V8 Mustang 1 ½ diameter
shorty. $75.00
• Cobra Jet rods (7) ARP bolts/resiz ...
1990 Mustang LX hatch 347, with only 42K on the
body and motor has seen no street time only raced
over at gateway international raceway for one full
season. Exceptionally clea ...