This as is in memory of Big Al, a Mustang Fanatic
since he was 15. He bought a '69 Fastback from
the original owner 11 years ago, and he never got
any further than that. Whe ...
'88 Mustang GT prepared for road-racing (not
street-legal), in NJ. Raced with EMRA, would also
be legal for NASA. The car had a lot of things
done and a lot of money spent (h ...
The car is completely redone and just needs a
roll cage. Here is a small list of some of the
things done there are so much i can keep going
on.
This car has been completely ...
1993 302 COBRA SHORT BLOCK WITH 40,000 MILES, 1970
351 WINDSOR HEADS WITH ROLLER ROCKERS, GUIDE
PLATES, HARDEN PUSH RODS, TALL ALLUMINUM FORD
VALVE COVERS, TAYLOR IGN WIRES, M ...
I am parting with my 86 GT in order to pay for
another one. I love this car, but I am just
looking to move on. The car has:
64k mile long block
Cobra INtake with 70mm TB
F ...
74 351W block with standard bore (4.00) in good
condition but needs to have the cylinders
"cleaned" to remove any rust from years of sitting
in my basement. Also, a Comp Cams ...
--------------------------------------------------
------------------------------
VORTECH V-1 T-TRIM (Race-M ) SUPERCHARGER
Brand NEW never used!
This system is for ...
General
1992 Mustang LX Hatch
Wild Strawberry Exterior / Black Interior
50K Original Miles Body, 8K Miles Engine /
Transmission
Excellent Condition
$14,000
Northern Ind ...
Unfinished 1985 Mustang GT project. This car is a
ground-up build that I started in 1998. I started
with a 65,00 mile bare shell from Florida and have
been building ever sin ...
This is a professionaly built Ford 351W Engine. It
consists of a 1979 block which is one of the
thickest 351W blocks ever made. This brand new
engine has been Pressure Tested ...
I need a 351w roller cam block. They were found in
trucks 1995 and up. I will be boring it out to
.040" so a small ridge should be no problem.
Perfer local I'm in Rhode Island